WARN 9.5XP Winch
This is a brand new WARN winch 9.5XP.
It is one of the only Warn winches that have the powerful 6HP motor as standard. Making for quicker line speed and higher stall load, it has the longest duty cycle and fastest line speed of any STD WARN winch under load!
With 9,500 lbs. (4,310kgs) of pulling power, the 9.5xp delivers extreme performance that you can rely on with the WARN name. The 6hp motor, 3-stage planetary gearing and continuous duty control pack work together to tackle the most challenging winches you may face.
Full face contact drum seals, motor and end housing gaskets deliver extreme-duty water resistance. A high gloss, chip resistant powder coat finish over chromate coated alloys affords superior corrosion resistance.
9.5XP SPECS
Part Number: PN 68500 9.5xp winch, 12V
Rated Line Pull: 9500 lbs. (4310 kgs.) single-line
Motor: 12V 6hp, High Output Parallel Series Wound
Remote Control: Remote, 12' (3.7m) lead, S2 elements, integrated flashlight
Gear train: 3-Stage Planetary
Gear Ratio: 156:1
Lubrication: Aeroshell #17
Clutch (free spooling): Sliding Ring Gear
Brake: Automatic Direct Drive Cone
Wire Rope: 100', 5/16" diameter (30m, 8mm diam.)
Fairlead: Roller
Recommended Battery: 650 CCA minimum for winching
Battery Leads: 2 gauge, 72" (1.83m)
Finish: Chromate with high-gloss dark grey powder coat
Drum Diameter/Length: 2.5"/9.0" (6.4cm/23cm)
Weight: 87 lbs. (39.5 kgs.)
12V DC PERFORMANCE SPECS
|
Line Pull Lbs.(Kgs.) |
Line Speed FT./min(M/min.) |
Motor Current |
Pull by layer layer/Lbs(Kgs.) |
|
0 |
38(11.6) |
70 amps |
1/9500(4313) |
|
2000(910) |
16.8(5.1) |
175 amps |
2/8650(4927) |
|
4000(1818) |
12.8(3.9) |
262 amps |
3/7920 (3595) |
|
6000(2720) |
10.1(3.1) |
335 amps |
4/7400(3359) |
|
8000(3630) |
8.8(2.7) |
425 amps |
5/6940(3150) |
|
9500(4310) |
7.6(2.3) |
480 amps |
Above performance specs are based on first layer of drum
Winch Dimensions: 577mm L. x 160mm D. x 196 mm H
Please check the length measurements to ensure it will fit your vehicle, Due to the 6hp this winch is a bit longer than most, In most cases a little grinder work will allow it to fit to majority of vehicles.
Mounting Bolt Pattern: 10.0" x 4.5" (254mm x 114.3mm)
(Std mounting spacing on all commercially available winch bars)
It is recommended a 650CCA (Cold Cranking Amp) Battery be used with this winch to ensure it receives the power it needs to operate to specs without failure, Smaller batteries will increase the amount of amps being drawn from the battery, creating heat and as a result possibly burn out the contacts in the motor.
