Here is an ADR compliant and airbag compatible bull bar to your WK2 Grand Cherokee for some serious protection.  Be it from animal strikes or offroad obstacles you can keep that front end straight and clean. 

Can be purchased in classic style with 3 hoops, or Urban style with single hoop. This bar is a full steel construction and really suits the lines of the vehicle. 

 Suits all Laredo, Limited, Overland and Summit models years 2011-2017

• ADR compliant
• Airbag compatible
• Proudly made in Australia
• Works with ACC camera and parking sensors
• Works with Jeep Air suspension system
• Winch compatible,  Suit most winches and brands
• Smooth entry for winches with plasma rope
• Air vents incorporated into the front of the bar and skid plates
• 20mm Steel Tow points included (x2)
• High lift jacking points included (x2)
• Bull bar constructed from 3 and 4mm steel, tow hooks 20mm steel
• Top hoops fully welded to bar for added strength in classic version.
• Optional Urban style instead of full hoops (bolt on or welded grill guard only)
• Grill guard tube is 3" diameter with 2" outer wings
• Provisions for driving lights and radio antenna (x2)
• Steel skid plates all around bottom of bar to protect Quadralift compressor and washer bottle
• Provisions for Active Cruise Control and parking sensors
• As standard LED fog lights and LED indicators included in the bar with all protected by a polycarbonate cover.
• Lights are mounted in a steel box which strengthens the wing. Competitors cut a huge portion of their wings (which weakens them dramatically) then add in a brittle plastic holder for the the lights which adds no strength to the wing.
• Shot blasted and powder coated in a durable texture black finish or colour matched
• Colour matching available
• Works with Uneek 4x4 bash plate https://www.uneek4x4.com.au/wk2-grand-cherokee-bash-plate/
• Winch packages available.

 Special note for Overland and Summit models:

1. Uneek 4x4 will not be held responsible for damage to the ACC camera in removing it or fitting during the install. In very extreme cases the ACC sensor may need to be aligned by Jeep at your cost.

2. While the bar does fit a Summit model you will notice the bar will appear to be 25mm short near the flares as the factory flares are wider by 25mm

Uneek 4x4 highly recommends vehicles fitted with steel springs to upgrade their suspension to prevent sagging.  A perfectly matched suspension system is available here CRDSTU 2.5" lift to 2.75" lift

*Shipping Rates

*Note
The above listed fixed shipping rate applies to customers within the metro area of Melbourne, Sydney, Canberra, Adelaide and Hobart. Rates for Brisbane, Gold Coast and Perth are listed below:
Brisbane              $200
Gold Coast          $200
Perth                     $230

If your location does not fall within these areas then please call our friendly staff for a quote today.

Alternately, place your order with the Metro shipping fee and our staff will call you directly to confirm any changes to the shipping cost.

Fitting time: 5-6 hours

Install difficulty: 6/10